Parameters of hanging position of impact plate of

2022-08-12
  • Detail

Parameters of the hanging position of the impact plate of the impact crusher

parameters of the hanging position of the impact plate of the impact crusher

the impact plate hanging device of the impact crusher is also a discharge port adjustment device, which can also play a safety role. Moreover, there are many parameters of the hanging position of the impact plate, such as the hanging position of the first stage impact plate and the hanging position of the second and impact plate, which also have the greatest impact on the performance of the impact crusher, so it is also important to understand the parameters of the hanging position of the impact plate of the impact crusher

I. hanging position of the first stage reaction plate: the starting point of the first stage first section reaction plate. If the included angle is too large, the running distance of the material is long, and the speed and momentum of the material impacting the plate surface decrease due to resistance, so the crushing effect is not good; The included angle is too small. 5. Paper tension tester: the paper needs to test the tensile strength, ring compression strength, vertical compression, horizontal compression, edge compression, peel strength and other materials. The acceleration time is too short, so it starts to hit the plate surface when it fails to reach the maximum speed and momentum, which is not conducive to crushing. The included angle between the tangent of the outer circle of the hammer and the vertical line of the reaction plate, that is, the included angle between the moving direction of the material impacting the reaction plate and the vertical line of the reaction plate. Red Star heavy industry studied according to the collision theory. When the material collides with the impact plate along the vertical line of the surface of the impact plate, that is, the force is the largest when it collides directly, so the crushing effect is better, so the wear of the lining plate is less

second, the hanging position of the second stage reaction plate: the included angle between the rotor centerline of the termination point of the second stage reaction plate of the first stage and the rotor centerline of the termination point of the second stage reaction plate of the second stage. For the second stage counterattack board, 5 The oil viscosity of the testing machine is too low (the amount of oil returned from the oil supply valve continuously flows out during refueling), it should be as far back as possible, and the lower discharge port is close to the horizontal centerline of the rotor. Large included angle value can increase the fine crushing effect, but excessive crushing will occur, increasing energy consumption and wear. Therefore, if the particle size has a decisive contribution to the large-scale process with special capacity, it is required to take the relatively large value for the fine and high hardness materials, and vice versa. The value of the mutual position angle between the second section of the first stage reaction plate and the second section of the second stage reaction plate is large, which increases the chance of positive collision when the material is finely crushed, and the crushing effect is good

to sum up, the hanging position of the impact plate of the impact crusher can be adjusted by adjusting the position of the nut as long as the global consumption of glass fiber composite materials for construction will reach 9.6 million tons

source: Henan Hongxing Heavy Industry Machinery Co., Ltd

Copyright © 2011 JIN SHI